Dimensions of the coffin plane are 7.5″ X 3″ X 2.75″ with a 2″ iron 5″ long. This plane has an adjustable mouth to compensate for wear. A very tight mouth produces extremely fine shavings and little tear-out. The plane is available with a 45° iron for normal use on most woods. A 50° iron for figured and most woods, 55° for high figured woods, or a 60° iron for use on very figured woods is available. With a 45° and 1/4″ thick iron, this finish plane will slice curly maple with little or no tear-out. This plane works great with small to large hands.

Tired of awls which won't hold a point and which bend during use? CTW awls are designed for hand comfort and durability. The O-1 tool steel blades are taper ground and hardened to Rc 62-63 for approximately 2 inches of their length and terminate in a fine point. The handles are, like the marking knives, made from exotic and figured domestic or tropical hardwoods and are available to match the marking knives. They are also available in customs sizes and woods by special order. Use them to start screws, mark drilling locations, or even in place of a marking knife to scribe layout lines.

Marking knives need to hold an edge well, be stiff enough not to flex, and they must be narrow enough to fit into confined areas such as dovetails. CTW marking knives are made from 3/32" thick precision ground O-1 tool steel and are 5/16" wide. The blades are individually hardened to Rockwell C 62-63 so they will hold an edge and they are shipped honed and ready to use. I feel that tools should be ready to go and should not be sold as a "kit". Knives are roughly 7 1/2 " long overall and are shaped in what I call a pencil form. Everyone uses pencils and pens and you should immediately feel comfortable holding and using this knife. A fine tool for the serious hand tool user.

Pocket Planes are used to put the final finish on your work. (Less work and a far better finish than sanding.)
A small plane with a 1.5" iron... made for small or tight areas. It is 5.5" long and has the same fine features as my regular planes. Constructed with a very tight mouth for the finest of shavings.

The Jointer Plane is used to level a surface and make it flat, or join edges for good glue ups. It serves the same purpose as a power joiner, but is much quieter
This plane is approximately 24" X 3" X 1.75" with a 2" iron with an Ipe adjustable mouth block . Although shipped with a tight mouth, the mouth is adjustable.The razee jointer is approximately 24"x3"x2.75 with a Stanley #8 the jointer can be made up to 36" long.