Knight Toolworks Products

CTW Plane Hammer

Mon, 06 Sep 2010 16:44:29 -0700

CTW plane adjusting hammers are designed specifically for adjusting the blades and wedges of wooden planes and infill hand planes. The polished brass and Lignum Vitae head is weighted toward the brass striking end and is designed so it won't mar or mushroom your blade like a steel hammer. The Lignum end is of a smaller diameter and is used to tap the heel or toe of the plane to adjust the blade without leaving dent mark in the wooden body. It should also be used to tap plane wedges tight to prevent damaging the heel of the wedge. The handles are individually shaped from quartersawn White Ash with the grain oriented to avoid the runout which weakens many other hammer handles. Finished with 3 coats of boiled linseed oil, the handles provide a good grip and avoid the slipperiness of the more commonly used lacquer finish. If you own or use infill or wooden planes, you owe it to your planes to use one of these hammers. Total weight is 8 ounces.

CTW Awl

Mon, 06 Sep 2010 16:44:29 -0700

These awls are offered by Chester Tool Works. (Woods from top are: East Indian Rosewood, Gabon Ebony, Brazilian Tulipwood.)

Scrub plane kit

Mon, 06 Sep 2010 16:44:29 -0700

The Scrub Plane is used for hogging off wood. It can take warped boards or boards that are too thick and plane them close to their finished thickness very fast.

This great scrub plane is 9" long. It features a 1.5" iron. It will be the easiest-to-use scrub plane you will own.

Razee Jack Plane Kit

Mon, 06 Sep 2010 16:44:29 -0700

The Jack Plane is used for hogging off wood, leveling, flattening, and smoothing surfaces.

Approximately 15" X 3" X 1.75" This plane comes with a 2" iron, an adjustable Ipe mouth The wider mouth opening is for larger shavings. Two pounds of additional heft can be added. The razee jack is approximately 15" X 3" X 2.75" with a closed tote.

Pocket plane kit

Mon, 06 Sep 2010 16:44:29 -0700

Razee Jointer plane kit

Mon, 06 Sep 2010 16:44:29 -0700

All Kits are easy to build with self aligning 2 piece bodies. Sides are aligned with dowel pins. Kits consist of two plane sides; two dowel pins, two wedge blanks. Slotted and non slotted mouths block a tote and hardware (if the plane comes with a tote) and screws if appropriate.

The plane bodies are shipped in the original block to keep them from warping.

Coffin Finish/Smoothing Plane Kit

Mon, 06 Sep 2010 16:44:29 -0700

The smoothing plane is used to put the final finish on your work. (Less work and a far better finish than sanding.) The coffin plane is great: just get behind it and push all day! It’s good for large surfaces too!

CTW Marking Knife

Mon, 06 Sep 2010 16:44:29 -0700

These knives are offered by Chester Tool Works. (Woods from top are: Snakewood, Gabon Ebony, Brazilian Tulipwood, East Indian Rosewood.)